Wireguard Endpoint FQDN and Routing
SO i currently have Wireguard running on my ER8411 and have other sites connected to it, I am currently using WRT1900AC routers to make that connection but I have been looking to setup those sites with ER605s but i have been running into 2 issues.
1. I currently use a dynamic DNS Service since my IP is not Static, and on my current WRT1900s i can use a URL for an endpoint but the Omada routers will only allow a IP Address. is there a way around this or does anyone have a solution to this?
2. I am currently using Policy based routing on my WRT1900s to force some clients over the VPN and others over WAN, I was digging through the controller software to see if I could find anything that would allow this but I haven't been able to find any function that would do the same, so I was thinking about setting up a new VLAN and configuring it to run over the VPN if possible. any ideas on configuration for this?