Point Omada switch port at specific WAN?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I thought this would be simple, but I must be missing something.
What are the steps to take in order to route a specific port on the switch to a specific WAN?
I have WAN1 and WAN2 load-balanced, but want port4 on the switch to route to WAN1 no matter what.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@EchoKos Configuring a policy routing on the router should fix it
- Copy Link
- Report Inappropriate Content
@ddtt1024 I agree, but I find no routing policies I can create (in Omada) that route to specific WANs.
- Copy Link
- Report Inappropriate Content
You have two options
1. if it's just 1 device you wanted hard-routed, create an IP object and assign a Policy Route for that IP grouping which is within your default LAN via WANx
2. if you want any device on that port to get hard routed, then create a new VLAN+subnet, assign it to that port, and create a Network policy route for the VLAN subnet via WANx
I use both and they work just fine for me.
- Copy Link
- Report Inappropriate Content
It turns out that when creating the vLAN, the profile wasn't automatically created. I created the profile and assigned it to the port on the switch and now all seems to be working. @d0ugmac1's #2 answer was the rest of the solution.
- Copy Link
- Report Inappropriate Content
Pro Tip :)
Depending on what those devices are/are doing, you may want/need to use the DNS server IP's from the desired WAN port as the custom DNS for your hard routed VLAN.
Glad you got this running!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 700
Replies: 5
Voters 0
No one has voted for it yet.