Meshing with European Channel Limit
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm trying to setup a mesh between an EAP225 (EU, v4.0, firmware 5.1.0) and an EAP225-Outdoor (EU, v1.0, firmware 5.1.0). When testing everything, this just worked without problems.
Then I found the "Channel Limit" option that (to my understanding) disables some channels to make the APs adhere to local regulations here in the EU and enabled it.
From that moment, meshing stopped to work (reliably): when I remove the uplink from the EAP225-Outdoor, it no longer meshes but either remains disconnected of the adoption fails.
To make meshing work again, I disable "Channel Limit", connect the EAP225-Outdoor (so that it get's the config change) and then disconnect it again: it meshes as expected.
Is this a known issue, that enabling "Channel Limit" breaks meshing? Is there anything I can do about this?
