Hi @mictain 

Thanks for posting in our business forum.

Description is not clear to me. So, the NVR keeps rebooting instead of the camera. The NVR itself experience a boot loop?

Is the power stable for the NVR?

If there are no cameras connected to the NVR, does it enter the boot loop?

It looks like a hardware issue. Is there anything changed since the last time you recall it worked well and stably?

@Clive_A

Yes the NVR itself boot loops, i think the power is stable, it is plugin to an extension where the monitor screen is also plugin, i think I'll try to plug it to a different power outlet just to isolate the problem.

The NVR stop boot looping when ever i disconnect all the cameras, removing all connected camera prevents the NVR from boot looping, but i have to remove the NVR from the network by plugin out the LAN cable so i could access the NVR and remove the cameras from the NVR.

By the way all the camera connected to the NVR are all wireless, this never happened before i was using wired cameras, the NVR was stable back then.

It seems the wireless camera is messing up the NVR to boot loop, the only work around I manage to do for the NVR to work is to stay at the settings UI, because when I try to view the camera from the monitor that's the boot looping starts.

Hi @mictain 

Thanks for posting in our business forum.

mictain wrote

@Clive_A

 

Yes the NVR itself boot loops, i think the power is stable, it is plugin to an extension where the monitor screen is also plugin, i think I'll try to plug it to a different power outlet just to isolate the problem.

The NVR stop boot looping when ever i disconnect all the cameras, removing all connected camera prevents the NVR from boot looping, but i have to remove the NVR from the network by plugin out the LAN cable so i could access the NVR and remove the cameras from the NVR.

By the way all the camera connected to the NVR are all wireless, this never happened before i was using wired cameras, the NVR was stable back then.

It seems the wireless camera is messing up the NVR to boot loop, the only work around I manage to do for the NVR to work is to stay at the settings UI, because when I try to view the camera from the monitor that's the boot looping starts.

It enters the loop no matter if anything is connected to it or not, you should consider the RMA. I don't know why would it happen but the reboot loop does not seem to be right so far.

RMA and see if the new one behaves the same or not.