EAP225 disconnected
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have 2 identical EAP225-Outdoor V1.8 APs. I have wifi camera's connected to them, 2 weeks ago they stopped working. After a lot of analysis I found the AP's stopped working - they were connected but no traffic. I saw through the controller that an update was pending - so I did the update. After the update the AP's would not reconnect. When I try to adopt, it wants user name and password which it doesn't seem to take (and I have never changed). I'm stuck, can't do a factory reset (at least with the online instructions) and it's work great for 4 years and after this update, boom, dead in the water. I tried to recover from a previous backup - no good. I've jacked with it a couple hours and no joy. What is my next step?
Hi @RockHopper
The controller will assign an user account to EAPs once EAPs are managed by it. You may find the User account by going to Site window > Settings > Site, check the Device Account and try it.
Hi @RockHopper
The controller will assign an user account to EAPs once EAPs are managed by it. You may find the User account by going to Site window > Settings > Site, check the Device Account and try it.
