how to turn off SFP WAN on v5.13?
I have ER7206 as the router
Omada SDN is hosted on my Raspberry Pi With Raspberry Pi OS.
I don't have WAN on SFP. It bothers me to see it's Offline all the time. I can't disable it in Settings.
---
How do I turn it off the SFP WAN? It's not like this before v5.13.xx.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @YuukiA,
In Controller v5.13, the default status of WAN ports that can only be used as WAN ports is enabled and cannot be changed, refer to the following figure:
This is not a Bug, but an result of the optimized for WAN ports on the Controller v5.13. Thank you for your valuable feedback. I will record this request and report it to the developer team for evaluation.
- Copy Link
- Report Inappropriate Content
Hi @YuukiA,
In Controller v5.13, the default status of WAN ports that can only be used as WAN ports is enabled and cannot be changed, refer to the following figure:
This is not a Bug, but an result of the optimized for WAN ports on the Controller v5.13. Thank you for your valuable feedback. I will record this request and report it to the developer team for evaluation.
- Copy Link
- Report Inappropriate Content
Thank you for the reply. So can I assume in the future, we will not have the option to turn off SFP WAN in v6.0 as well?
- Copy Link
- Report Inappropriate Content
Hello @YuukiA,
Please note that the information provided here is based on the current information we have, it's provided for informational purposes only, not a guarantee or a promise. Any plans are subject to change, the final firmware releases shall prevail.
- Copy Link
- Report Inappropriate Content
@Hank21 I distinctly remember having the SFP port disabled in the controller before 5.13.x, and I really hope in a future update you can again disable SFP port, if it's not being used.
- Copy Link
- Report Inappropriate Content
It's really frustrating on the Home Dashboard for "ISP LOAD", that the "SFP WAN" is the default view. This has NO DATA for me. I use WAN only
So every refresh the page goes back to SFP WAN and no data.
This was not the case in 5.12.x
DEFAULT / BAD
HAVE TO CLICK WAN - ANNOYING
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 1084
Replies: 5
Voters 0
No one has voted for it yet.