Mesh between EAP615-Wall and EAP225-Outdoor not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi!
I'm currently trying to connect an EAP225-Outdoor Access point (v3 and firmware 5.1.1) to an EAP615-Wall (v1 and firmware 1.2.3) Access point via Omadas MESH feature.
Unfortunately I can't get it working. After I hit ADOPT on the devices page the following occurs:
The status from EAP225 changes to:
Is Adopted, then: Deployment, then: Configured.
The Configured status lasts for about 5 or 6 minutes. Then it changes to: connection interrupted
Don't know what to do now. Cannot get mesh working.
My hope is that someone here has a good idea how I could get it to work
Thanks in advance.
Patrick
Worked fine for me, don't forget to apply the WLAN profile after it's adopted and connected:
Performance via the 225 meshed to 615 (about 1m distance...so not 'real world'...but indicative that the system can perform well)
Worked fine for me, don't forget to apply the WLAN profile after it's adopted and connected:
Performance via the 225 meshed to 615 (about 1m distance...so not 'real world'...but indicative that the system can perform well)