5.13 Controller not showing ER605v1 ports?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

5.13 Controller not showing ER605v1 ports?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
5.13 Controller not showing ER605v1 ports?
5.13 Controller not showing ER605v1 ports?
2024-01-01 23:57:00 - last edited 2024-01-04 02:05:07

Noticed that graphing detail was missing today.  Should I not be able to tell which port the 2nd and 3rd items are connected to?  I suspect they may be the same device (my Pi clone running the latest controller), but I would like to see the port it is attached to.

 

<< Paying it forward, one juicy problem at a time... >>
  0      
  0      
#1
Options
1 Accepted Solution
Re:5.13 Controller not showing ER605v1 ports?-Solution
2024-01-04 02:05:03 - last edited 2024-01-04 02:05:07

Hi @d0ugmac1,

 

After confirming with the engineer, it doesn't support showing the Omada Gateway's LAN port numbers, and thanks for your valuable feedback, I've recorded this request and will report it to the developer team for evaluation.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#4
Options
3 Reply
Re:5.13 Controller not showing ER605v1 ports?
2024-01-02 09:32:10 - last edited 2024-01-02 09:33:14

Hi @d0ugmac1,

 

Thank you so much for taking the time to report the issue to our community!

May I know whether this issue occurred after the controller firmware was upgraded?

Can you be sure which device is connecting the router's ports?

What is the firmware version of ER605 V1? Can a reboot fix it?

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#2
Options
Re:5.13 Controller not showing ER605v1 ports?
2024-01-03 18:41:42

  @d0ugmac1 

 

Sorry Hank, I might be chasing ghosts.  It looks like only the router WAN and all switch ports get labelled.  No router/gateway LAN ports are labelled...is this by design?

<< Paying it forward, one juicy problem at a time... >>
  1  
  1  
#3
Options
Re:5.13 Controller not showing ER605v1 ports?-Solution
2024-01-04 02:05:03 - last edited 2024-01-04 02:05:07

Hi @d0ugmac1,

 

After confirming with the engineer, it doesn't support showing the Omada Gateway's LAN port numbers, and thanks for your valuable feedback, I've recorded this request and will report it to the developer team for evaluation.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#4
Options

Information

Helpful: 0

Views: 364

Replies: 3

Related Articles