ER605 - OpenVPN split
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I have recently set up an OpenVPN Client using my NORD account details. All is working well, problem is I only want it to apply/effect traffic from a specific VLAN.
I have created three VLANS (as below):
| ID | Name | Vlan | IP Address | Subnet Mask | DHCP Server | DHCP Relay | Operation |
|---|
| 1 | VPN | 40 | 192.168.40.1 | 255.255.255.0 | Enabled | Disabled | ||
| 2 | WORK | 20 | 192.168.20.1 | 255.255.255.0 | Enabled | Disabled | ||
| 3 | LAN | 50 | 192.168.50.1 | 255.255.255.0 | Enabled | Disabled |
I would like VLAN 40 / "VPN" to be subjected to the VPN (everything inbound/outbound is protected) and the remaining two ("WORK" (20) & "LAN" (50) to be unprotected.
Currently the VPN is being applied to all connections regardless of which VLAN they reside.
For additional info:
Port 1 is WAN
Port 2 is WORK Switch
Port 4 - VPN AP (Wireless AP Dedicated to providing VPN access in premises) - essentially if private use needed they switch to this AP and all traffic protected
Port - 5 LAN (Everything else with normal use case)
Hi @Todge
Thanks for posting in our business forum.
OK seems to me did not read it carefully. So, your device working as the client, right?
But if you want to specify what traffic goes through the VPN, then, it should be a setting on the server which either be a full tunnel or a split tunnel.
