Setup dual WAN, how to force devices on specific VLANs touse use a specific gateway/WAN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm just setting up a new ER707-M2 router. I'm not using an Omada controller for it yet, but maybe later.
I currently have it setup with two separate WAN connections, each with their own public IP address, of course. I do not want to use the dual WAN config for fail over, but I do want to force VLANs to use a specific WAN.
As I have it setup now, load balancing is disabled, each VLAN has a different /24 subnet, and I've configured the VLAN/LANs to use separate gateway IP's.
However, it seems that traffic from both VLANs is randomly connecting thru either of the WAN IP's.
As an example, I'm trying to force all devices on vlan10 to only use WAN interface 1, and force all devices on vlan20 to only use WAN interface 2.
How can I force devices on specific VLANs to only move traffic thru specific WAN interfaces?
Thanks!
Thanks for the help Clive, setting up Policy Routing did the trick!
I found the Policy Routing settings, created a rule for each WAN interface, set the Mode to Only, and configured the necessary IP Groups and IP Address Lists to use for the Source IP field. Everything now works as intended.
Just leaving this here for anyone else that might need some extra info. 
Cheers!
Thanks for the help Clive, setting up Policy Routing did the trick!
I found the Policy Routing settings, created a rule for each WAN interface, set the Mode to Only, and configured the necessary IP Groups and IP Address Lists to use for the Source IP field. Everything now works as intended.
Just leaving this here for anyone else that might need some extra info.
Cheers!