Business Community > All Threads > EAP 235-wall rx packet drop high
< All Threads

EAP 235-wall rx packet drop high

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 235-wall rx packet drop high

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 235-wall rx packet drop high
EAP 235-wall rx packet drop high
2024-03-27 12:29:38
Model: EAP235-Wall  
Hardware Version: V1
Firmware Version: 3.1.1

I have 4 EAP-s 2x235 wall, one 245, and one 615-wall, the two 235-wall has a drop packet rate radio rx a rate of 30-50% percent. Is it a bad behavior? I deploy only 5GHz.

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:EAP 235-wall rx packet drop high
2024-03-28 06:33:53

 

Gmmg wrote

I have 4 EAP-s 2x235 wall, one 245, and one 615-wall, the two 235-wall has a drop packet rate radio rx a rate of 30-50% percent. Is it a bad behavior? I deploy only 5GHz.

 

Hi@Gmmg

What about your actual usage?  Will you suffer the unstable issue with these EAPs?

 

Please also go to Devices - select the EAP - on the pop-up page, is the channel acceptable? Please also try to run the WLAN optimization on settings - Wireless Netowkrs - WLAN optimization.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:EAP 235-wall rx packet drop high
2024-03-28 06:53:07 - last edited 2024-03-28 07:22:35

  @Hank21

Hi, No there is nothing like bad experience, only the bad diagram that bothers me. As well as all the two EAP235-wall shows this pattern, while the EAP245 and EAP615-wall does not.

I live in a rural area with zero interference on 5GHz, and set channels to 36, 40, 44 and 48 (auto ch width) respectively. Tried WLAN optimization, set higher channel for the EAP245 but the packet drop stayed with the two EAP235-walls. Otherwise did not realize much of a difference.

Actually without the monitoring capabilities of Omada controller I would have not realized any problem. You know, why even watch it..

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 498

Replies: 2

Related Articles
EAP 235-Wall V1 Firmware Update?
5501 3
EAP 235 Wall - Incorrect VLAN Assignment on LAN port after reboot
1575 0
Cannot configure new EAP-235 wall
579 0
Can I use EAP 235 wall with passive poe adapter?
1661 0
Change EAP 235 Wall US version to EU version
633 0
EAP-235 In-WALL MAP issues in Omada Controller
1763 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.