Built-in RADIUS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Built-in RADIUS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Built-in RADIUS
Built-in RADIUS
2024-04-23 14:12:26 - last edited 2024-04-23 14:14:06
Tags: #Built-in RADIUS
Model: OC200  
Hardware Version: V1
Firmware Version: 1.29.4 Build 20240304 Rel.54362

I recently enabled the Built-in RADIUS feature on the Omada Controller for testing purposes, and the deployment was successful. However, after removing the authorized clients and disabling Port Forwarding NAT, I encountered difficulty in deactivating it. Whenever I attempt to turn it off, an error message pops up stating, 'The built-in server is being used, failed to stop built-in RADIUS server.' Could you advise on resolving this issue?

  0      
  0      
#1
Options
1 Reply
Re:Built-in RADIUS
2024-04-23 14:37:43

  @choymits 

you must also remove all configurations that use radius server, SSID for example, before you can deactivate radius server.

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 495

Replies: 1

Tags

Built-in RADIUS
Related Articles