16ports switch connected directly to OMADA ER605
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have Tplink Omada ER605 and a 16ports Tplink switch. My question is can I connect the switch directly to Omada and control the bandwidth of each IP connected to the switch?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Jzoler
Thanks for posting in our business forum.
You have to configure the control on the router and specify the control to each IP address or you cannot.
The switch is a dummy switch, which means you have to limit the traffic from the router's port to the switch.
You can try this out but since the switch is based on layer 2, the bandwidth control might not be effective on the switch but when they are back to the router, it is effective.
- Copy Link
- Report Inappropriate Content
Hi @Jzoler
Thanks for posting in our business forum.
You have to configure the control on the router and specify the control to each IP address or you cannot.
The switch is a dummy switch, which means you have to limit the traffic from the router's port to the switch.
You can try this out but since the switch is based on layer 2, the bandwidth control might not be effective on the switch but when they are back to the router, it is effective.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 357
Replies: 2
Voters 1