connect two VLANs on managed switch

connect two VLANs on managed switch

connect two VLANs on managed switch
connect two VLANs on managed switch
2024-07-01 16:03:44 - last edited 2024-07-02 02:21:03
Hardware Version:
Firmware Version: V3

Hello,

It is possible on an TL-SG2008 V3 switch where there is set up on Eth1, 2 and 3 VLAN01 and on Eth4, 5 and 6 VLAN02 configure also ports Eth7 and 8 where PCs conencted to this ports can communicate on bot VLAN1 and VLAN2 ?

So if I have a PC connected for example to Eth7 this macchine can communicate both ways with macchines on VLAN1 and VLAN2 ?

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:connect two VLANs on managed switch-Solution
2024-07-02 00:49:51 - last edited 2024-07-02 02:21:03

Hi  @ESM60 

 

You will need to create VLAN interface on the switch, and let the client devices use this switch as their gateway. 

 

The switch can create the routing between these VLAN interfaces. 

 

Here is an example:

How to build up a multi-nets network via Multi-Nets NAT feature on TP-Link router with L2+/L3 switches

ESM60 wrote

Hello,

It is possible on an TL-SG2008 V3 switch where there is set up on Eth1, 2 and 3 VLAN01 and on Eth4, 5 and 6 VLAN02 configure also ports Eth7 and 8 where PCs conencted to this ports can communicate on bot VLAN1 and VLAN2 ?

So if I have a PC connected for example to Eth7 this macchine can communicate both ways with macchines on VLAN1 and VLAN2 ?

 

 

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:connect two VLANs on managed switch-Solution
2024-07-02 00:49:51 - last edited 2024-07-02 02:21:03

Hi  @ESM60 

 

You will need to create VLAN interface on the switch, and let the client devices use this switch as their gateway. 

 

The switch can create the routing between these VLAN interfaces. 

 

Here is an example:

How to build up a multi-nets network via Multi-Nets NAT feature on TP-Link router with L2+/L3 switches

ESM60 wrote

Hello,

It is possible on an TL-SG2008 V3 switch where there is set up on Eth1, 2 and 3 VLAN01 and on Eth4, 5 and 6 VLAN02 configure also ports Eth7 and 8 where PCs conencted to this ports can communicate on bot VLAN1 and VLAN2 ?

So if I have a PC connected for example to Eth7 this macchine can communicate both ways with macchines on VLAN1 and VLAN2 ?

 

 

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 335

Replies: 1

Related Articles