"Scan" does not find obvious AP's. Yes I'm in client mode.

"Scan" does not find obvious AP's. Yes I'm in client mode.

"Scan" does not find obvious AP's. Yes I'm in client mode.
"Scan" does not find obvious AP's. Yes I'm in client mode.
2024-08-25 19:19:51 - last edited 2024-08-26 06:07:22
Model: CPE710  
Hardware Version: V2
Firmware Version: 1.0.3 Build 20230616 Rel. 34510 (5553)

My CPE710 does not find any AP's, even when I'm pointing it right at one. I'm in client mode, but I've tried all the other modes just in case. Once in a great while, it will find an AP that is far away. My laptop can find eight AP's easily.

 

Thx, tom.c

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:"Scan" does not find obvious AP's. Yes I'm in client mode.-Solution
2024-08-26 06:03:11 - last edited 2024-08-26 06:07:22

  @tcumming 

Please refer to this article Part I, Step 3:How can I set up the AP + Client topology successfully?

Please try to change the unit's location, as suggested in the article. Is your AP also model CPE710?


 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:"Scan" does not find obvious AP's. Yes I'm in client mode.-Solution
2024-08-26 06:03:11 - last edited 2024-08-26 06:07:22

  @tcumming 

Please refer to this article Part I, Step 3:How can I set up the AP + Client topology successfully?

Please try to change the unit's location, as suggested in the article. Is your AP also model CPE710?


 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:"Scan" does not find obvious AP's. Yes I'm in client mode.
2024-08-26 18:40:20

  @Hank21 

 

From the topo link you included, it appears that the CPE can only connect to another CPE via wifi.

 

Is that correct?

  0  
  0  
#3
Options
Re:"Scan" does not find obvious AP's. Yes I'm in client mode.
2024-08-27 03:39:37

  @tcumming 

Yes, two CPE units connect via a wireless link. One should be set as AP mode, and the other as Client mode.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 289

Replies: 3

Related Articles