Native vlan 1 change ID
Native vlan 1 change ID
Hi, I created a vlan ID 2 and I have to make the change with vlan 1. Then I have to disable the vlan 1.Which command line (CLI) should I set? Thanks for the help
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Sissilo
Thanks for posting in our business forum.
See the User Guide:
https://static.tp-link.com/upload/manual/2024/202403/20240305/1910013605_Managed%20Switch_CLI.pdf
- Copy Link
- Report Inappropriate Content
Hi @Sissilo
Thanks for posting in our business forum.
See the User Guide:
https://static.tp-link.com/upload/manual/2024/202403/20240305/1910013605_Managed%20Switch_CLI.pdf
- Copy Link
- Report Inappropriate Content
@Sissilo In the guide you indicated to me I find nothing that can help me. The switch is connected to a router that has VLAN port 2 in trunk mode. I have port 24 of the tp link switch configured in vlan 2 trunk Now configure as native or primary or default..... vlan2 and disable vlan 1 Please help me. Show the command line.....
- Copy Link
- Report Inappropriate Content
i'm not quite sure what you're trying but to disable vlan1 it's this command
no switchport general allowed vlan 1
- Copy Link
- Report Inappropriate Content
@Sissilo Ok now I'll give it a try and let you know
- Copy Link
- Report Inappropriate Content
@Sissilo Unfortunately, it doesn't work. Error: 'no' is not applicable
- Copy Link
- Report Inappropriate Content
then I don't know, dokumentation say this, I use the switch in controler mode but I think the comand is the same
- Copy Link
- Report Inappropriate Content
Sorry but I need to see all the complete commands.... Is this how I should write?
SG3428MP(config)#switchport general allowed vlan 1 1-24 untagged
SG3428MP(config)# no switchport general allowed vlan 1
Thank you very much
- Copy Link
- Report Inappropriate Content
this is one of my switch port config, vlan 300 is untagged
interface gigabitEthernet 1/0/1
description "cam"
switchport general allowed vlan 300 untagged
switchport pvid 300
no switchport general allowed vlan 1
dot1x mabFmt captal-with-bar
dot1x port-control authorized-force
dot1x port-method port-based
- Copy Link
- Report Inappropriate Content
So for my switch could I do this?
interface gigabitEthernet 1/0/1-24
description "none"
switchport general allowed vlan 2 untagged
switchport pvid 2
no switchport general allowed vlan 1
- Copy Link
- Report Inappropriate Content
yes if you want vlan2 untagged on all 24 ports, yes. but I don't quite understand what you're going to do, why change all 24 ports to vlan2, do you trunk on the sfp ports? how are your trunk ports?
and mybee you should use interface range like this to configure multiple port
interface range gigabitEthernet 1/0/1-24
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 125
Replies: 13
Voters 0
No one has voted for it yet.