Connected Client With Different Network Segment
My AP "P1-PRODUCTINO" is setup under 192.168.10.X network and notice some of my connected clients with 192.168.0.X network. Anything that I had miss configured?
Connected clients
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @ClassA
It is the DHCP server that determines what IP address the client will obtain. The EAP is not a DHCP server; it is just a client as well. Usually, the DHCP server is your router. Therefore, to figure out why this is happening, we need to make a judgment based on your network topology and configuration.
What's your requirement about the IP addresses? We may be able to offer suggestions based on your specific needs.
In the meantime, you may refer to the following:
How to configure Multi-Networks & Multi-SSIDs on Omada SDN Controller
- Copy Link
- Report Inappropriate Content
BTW, I do have one AP "TOOLING" in OMADA network but under 192.168.0.X network. Not sure whether this relate to why the client connected to "P1-PRODUCTION" AP but IP is from 192.168.0.X ?
- Copy Link
- Report Inappropriate Content
Hi @ClassA
It is the DHCP server that determines what IP address the client will obtain. The EAP is not a DHCP server; it is just a client as well. Usually, the DHCP server is your router. Therefore, to figure out why this is happening, we need to make a judgment based on your network topology and configuration.
What's your requirement about the IP addresses? We may be able to offer suggestions based on your specific needs.
In the meantime, you may refer to the following:
How to configure Multi-Networks & Multi-SSIDs on Omada SDN Controller
- Copy Link
- Report Inappropriate Content
@ClassA my i ask what kind of controller did u use?, cause i had some problem when i tried to add an AP to the controller :(
- Copy Link
- Report Inappropriate Content
Hi @Vincent-TP ,
Thanks for your advise.I have 2 VLAN ( .0.X and 10.X ) and each with DHCP server. All my APs are connected under 10.X and last week I added one new AP ( TOOLING is 0.X ). After sometime, just noticed P1-PRODUCTION also obtain 0.X IP.
What I need is when computer connected to "TOOLING", then will obtain 0.X IP and the rest will be under 10.X IP.
- Copy Link
- Report Inappropriate Content
Thank you so much for taking the time to post the issue on TP-Link community!
To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID is TKID241157092, please check your email box and ensure the support email is well received. Thanks!
Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.
Many thanks for your great cooperation and patience!
- Copy Link
- Report Inappropriate Content
I'm using TP-link OMADA controller. First of all, do you able to discover your new AP in the controller or you can use Advanced IP Scanner to check whether is discoverable within the current network.. Hope this help.
- Copy Link
- Report Inappropriate Content
@ClassA thanks for the reply, the AP can be adopted on the controller that i used..., but the problem is when i exit the controller or restarting my pc, the controller is unable to opened on the browser, it just downloaded the .jar file... did the omada controller work like this or theres something wrong with my controller?, thanks in advance.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 230
Replies: 7
Voters 0
No one has voted for it yet.