PoE Voltage Limiting howto on JetStream PoE+ Switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

PoE Voltage Limiting howto on JetStream PoE+ Switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PoE Voltage Limiting howto on JetStream PoE+ Switches
PoE Voltage Limiting howto on JetStream PoE+ Switches
2016-02-29 22:43:24
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hello Everybody!

A ran into a problem!
I must to drive some PoE device with my TL-SG3424P JetStream PoE+ switch.

But our PoE capable AP's are runnig on 24V PoE voltage level.
I'm affraid is if I connected a 48V PoE output of the switch Port

it will make a hardware fault on a PoE client device.

Does somebody knows, can I set up a the switch PoE Voltage output level to 24V with CLI command or with any other solution?

Greetings!
Deskov
  0      
  0      
#1
Options
1 Reply
Re:PoE Voltage Limiting howto on JetStream PoE+ Switches
2016-03-22 15:47:28
No,if your AP is 802.3af standard, the PoE switch will detect it automatically.
  0  
  0  
#2
Options