PoE Voltage Limiting howto on JetStream PoE+ Switches
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PoE Voltage Limiting howto on JetStream PoE+ Switches
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello Everybody!
A ran into a problem!
I must to drive some PoE device with my TL-SG3424P JetStream PoE+ switch.
But our PoE capable AP's are runnig on 24V PoE voltage level.
I'm affraid is if I connected a 48V PoE output of the switch Port
it will make a hardware fault on a PoE client device.
Does somebody knows, can I set up a the switch PoE Voltage output level to 24V with CLI command or with any other solution?
Greetings!
Deskov
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello Everybody!
A ran into a problem!
I must to drive some PoE device with my TL-SG3424P JetStream PoE+ switch.
But our PoE capable AP's are runnig on 24V PoE voltage level.
I'm affraid is if I connected a 48V PoE output of the switch Port
it will make a hardware fault on a PoE client device.
Does somebody knows, can I set up a the switch PoE Voltage output level to 24V with CLI command or with any other solution?
Greetings!
Deskov