ER 5120 not working fiber optic dynamic ip
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER 5120 not working fiber optic dynamic ip
Model :
Hardware Version :
Firmware Version :
ISP :
I have ER 5120 working for 6 months, than it stop no internet
I have fiber optic internet from their box (Alcatel Lucent) which gives me one feed of dynamic ip, 50/5 Mbps that goes to the er 5120 WAN (only using 1 WAN)
I have set up LAN 2,3,4,5 with rate control, under Network>switch>Rate Control, I have setup ingress and engress limits for each LAN
I am using 3 desktops, wifi , time clock
It was working fine for 6 months and stop, I called ISP they said i have too many devices and they reset the feed and working fine for 30min and stop no internet
If I connect the feed to my laptop it work fine than reconnect to er 5120 WAN no conductivity. I have unplug the ISP box waited reconnect, to WAN, no internet, but if take the ISP feed t my laptop it works
Help I am pulling my hair out
Thanks in advance
Neal da
Hardware Version :
Firmware Version :
ISP :
I have ER 5120 working for 6 months, than it stop no internet
I have fiber optic internet from their box (Alcatel Lucent) which gives me one feed of dynamic ip, 50/5 Mbps that goes to the er 5120 WAN (only using 1 WAN)
I have set up LAN 2,3,4,5 with rate control, under Network>switch>Rate Control, I have setup ingress and engress limits for each LAN
I am using 3 desktops, wifi , time clock
It was working fine for 6 months and stop, I called ISP they said i have too many devices and they reset the feed and working fine for 30min and stop no internet
If I connect the feed to my laptop it work fine than reconnect to er 5120 WAN no conductivity. I have unplug the ISP box waited reconnect, to WAN, no internet, but if take the ISP feed t my laptop it works
Help I am pulling my hair out
Thanks in advance
Neal da
