R1D2 wrote

Test mode is for testing only. It uses some frequencies outside the ones assigned to WiFi radio links. Only CPE210 devices also supporting those frequencies can connect to an AP in Test mode, but expect massive interferences depending on the country you live in.

As for the maximum number of clients, it depends on their usage patterns. Usually the bandwidth will drop significantly if there are too many users, maybe that's what you observe as a CPE that "hangs". If your clients are CPEs, then always turn on MAXtream mode if you have two or more clients to avoid bandwidth degradation due to the CSMA/CA carrier sensing method.

Thank you for the answer
But when i use test Mode,i only use normal channel ( 1-10 chanel ) but still, all client will be DC
is there any some bug according to test mode condition..?
other competitor brand working fine with their complement test..i hope tp-link will do the same way..

Hi I have a small problem with a Tp-Link cpe 210 antenna, set it as an access point to transmit wifi to a nearby home, it works perfectly but once the antenna is working by connecting to the signal it generates and that It works perfectly I can no longer then monitor it using 192.168.0.254 why ?? What should I change to monitor it again ?? A problem I can not solve and explain, if you can suggest something, it will surely be a whim, Thank you Marco.
marcodd3@hotmail.com

[QUOTE=R1D2;204406]Test mode will give you 4,000mW TX power instead of the allowed 100mW. Depending on distance to the clients they could disconnect just b/c of signal distortion.

In professional WiFi setups one would try to lower the TX power rather than increasing it, b/c of such interferences. This rule doesn't necessarily apply to directional links (i.e. two or more CPEs talking to each other), but for sure it applies to a PtMP setup of one CPE feeding several standard devices.

Maybe a picture explains this better: :)



i just know it will give power 4000 mW.....but the specificatiom max is 27 dbm mean only 500mW ,anyway..i just set power for only 20 dbm but still all client will be DC.this happend not only me..

I just know than test mode will give power 4000mW...but the specification only max 27 dbm mean only max 500mW,anyway i just set power 20 dbm..but still all client will be DC