EAP 225, No SSID after adoption

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 225, No SSID after adoption

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 225, No SSID after adoption
EAP 225, No SSID after adoption
2017-07-10 03:55:08
Model :

Hardware Version :

Firmware Version :

ISP :

I have two EAP 225 APs. When I adopt them into the controller software the controller shows "provisioning" and does not connect. When I then login to the web interface of the APs, they are without an SSID. The previous default SSID or any new one that I set using the web interface on the AP, is removed and the SSID is blank. What to do? So far I cannot use the Controller.
Dwight
  0      
  0      
#1
Options
1 Reply
Re:EAP 225, No SSID after adoption
2017-07-13 09:16:34
Did you try to uninstall the EAP Controller and adopt the EAP again? It seems that the EAP Controller erased the AP's original configurations but didn't issue the new configurations. The problem maybe caused by the abnormal behavior of the EAP Controller.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 866

Replies: 1

Related Articles