CPE210 connection via Lan0 and 1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 connection via Lan0 and 1
Model : CPE210
Hardware Version :
Firmware Version : 1.1
ISP : Orange
New user so have no real experience of what the unit can do.
Have set 2 individual powered CPE210 units up as Access points to give wireless access, across our sons small campsite, back to an Orange Livebox.
Have used different IP's on both units and all works well.
We now need to cover a blackspot in the area of one of the units and thought we would use a second CPE210 and use the PoE to power the new unit, on the same pole.
We have used the same subnet for the new unit as the existing one and set the PoE on the original. The new unit powers up, but cant seem to see the wireless access point we have set on it. The original unit still has connection to the setup on that.The new unit we have set up the same as the original with multiSSP but different names of course for the wireless connections.
Also not clear on the instructions as we have IP of 192.168.0.253 on original unit and set the new one as 192.168.0.250 on the one we attached to that, with the PoE on the original. I take it this is correct, but not 100% sure.
Any help would be appreciated as i'm helping them out over teamviewer connection as not on site with our son. Many Thanks.
Hardware Version :
Firmware Version : 1.1
ISP : Orange
New user so have no real experience of what the unit can do.
Have set 2 individual powered CPE210 units up as Access points to give wireless access, across our sons small campsite, back to an Orange Livebox.
Have used different IP's on both units and all works well.
We now need to cover a blackspot in the area of one of the units and thought we would use a second CPE210 and use the PoE to power the new unit, on the same pole.
We have used the same subnet for the new unit as the existing one and set the PoE on the original. The new unit powers up, but cant seem to see the wireless access point we have set on it. The original unit still has connection to the setup on that.The new unit we have set up the same as the original with multiSSP but different names of course for the wireless connections.
Also not clear on the instructions as we have IP of 192.168.0.253 on original unit and set the new one as 192.168.0.250 on the one we attached to that, with the PoE on the original. I take it this is correct, but not 100% sure.
Any help would be appreciated as i'm helping them out over teamviewer connection as not on site with our son. Many Thanks.
