@modebm It is recommended to check the settings on the controller, most likely the EAP ACL entry is set, or you can go to the switch ACL and see if there is a relevant entry.

@JohnInOlympia The Client CPE can be connected to a switch, but in this case there is only a wired network, because the Client CPE itself does not broadcast a Wifi signal and the switch does not...

@RickJamesBish I think it is OK, because the CPE only acts as an extension of the WiFi signal, the back connection to the EAP is discoverable and manageable by the controller. Then the mesh can be...

@Bjcanada Yes, you can use two EAPs to build the mesh, and the EAPs can also supply the network to the back-end devices with a network cable. However, if you are feeding the router, it is recommended...

@bokbernie First of all, you need to check if this PC can ping through to the IP address of ER7206? If it can ping through, you can try changing different web browser, clearing the browser cache and...

@robladw Generally speaking, VLAN settings are based on the entire network, so if you want a particular VLAN to work you need to make the corresponding settings on all devices. Check this:...