@Thommes Yes, you must have an Omada switch and you need to send the set profile to the switch port, currently there is no way to send a profile to the router port. Take a look: How to configure...

@satelite Check this: https://community.tp-link.com/en/business/forum/topic/577364

@NJJay It is recommended that you can configure storm control to prevent multicast. But why is there a multicast storm you might want to check your network again.

@PascoS Is the WAN IP of the gateway at both ends the public IP? Are both routers showing "connected" on the controller? Go to Insight -----VPN Status, and check if the tunnel was built successfully?

@innav All settings are set on the controller and once you adopt a new device, the controller will send down the same settings and sometimes you just need to simply apply them on the new device.

@ifi5 How far away from the CPE is the modem you are using to connect to? If the distance is too far, as the network communication is mutual, it is recommended that 2 CPEs do point-to-point for...