@Kash01976 Is your EAP225 wired or wirelessly connected to your network? Have you tried resetting the EAP and then using controller adopt again? Generally speaking Forget does not mean you have reset...

@Luzifer Hi, Are you sure your settings are OK? Did you have similar problems before upgrading the controller's firmware? Did you apply the WiFi SSID to the EAP? Is the SSID still visible after...

@shberge I set up the DFS channel but did not reproduce your problem, perhaps you could tell me the whole process of reproducing the problem.

@Paul-2 EAPs are primarily used as APs to extend the WiFi coverage of devices such as routers, not as receivers to receive WiFi signals. It is usually wired to the router and then broadcasts the WiFi...

The switch may not be able to count the traffic of each client under the same port by the IP address, it can only count traffic by the port as it's a layer2 device. You can refer to the similar post:...

@rodegg Hope this can help you: https://www.tp-link.com/support/faq/3262/ https://www.tp-link.com/support/faq/3292/