@CrazyNetwork If I understand correctly, your current topology is: ISP Routers----ER605(OpenVPN server), and here is a client which is out of ISP routers need to connect to VPN Server. This is what I...

@Jimblas It is recommended to check that the Client CPE is connected to the AP CPE. You can check the Radio status by going to the Client's Status screen. Also check whether the device behind the...

@CrazyNetwork Based on your network topology, here is double NAT in your network, if you wanna set ER605 as VPN server, you need to open the ER605's WAN IP and Open VPN ports which is needed to use...

@Libik As far as I know, it should not be supported, so you can search and investigate to see if you can do it with other software.

@Lampadina Mesh EAP shows Isolated status, it means in the mesh network, the APs can send ARP request packets to a fixed IP address to test the connectivity. If the link fails, the status of these...

@ndm275 If I didn't guess wrong, your EAP's firmware should be CA version, it only supports Band4, no support DFS channel(Band 2.3).