ZandrMLV1Online
Following: 0Followers: 0
Forums/ Switches
2023-05-17 14:10:00
Re:TL-SG3210XHP-M2 - [Port]/6/Reload port Tw1/0/x phy firmware.
@IctEss There's no power switch and no 'clean shutdown' in software. So it's not like I could have done anything differently.
0HELPFULS
Forums/ Switches
2023-01-10 16:29:07
Re:TL-SG3210XHP-M2 - [Port]/6/Reload port Tw1/0/x phy firmware.
@IctEss Both of mine failed just unplugging them as I was reworking my server closet. I should follow through on the RMAs now that v2.6 exists.
1HELPFULS
Forums/ Switches
2022-05-17 14:55:20
Re:TL-SG3210XHP-M2 - [Port]/6/Reload port Tw1/0/x phy firmware.
@Utmstgsn I've gone through 2 in 6 months. The first one was after a power outage, but it was behind a UPS, so there was no surge. It's not like there's an orderly shutdown anyway. The UPS ordered a...
0HELPFULS
Forums/ Switches
2022-04-17 05:03:30
Re:TL-SG3210XHP-M2 - [Port]/6/Reload port Tw1/0/x phy firmware.
This is not 'damage'. I have now had two of these switches fail in exactly the same way, One died while still running 1.0.3, and the second one just died today running 1.06. The switches last a few...
0HELPFULS
Forums/ Controllers
2021-11-15 01:46:00
Re:Keep PPPoE connected?
Yes, the line is stable (now). There have been issues in the past, but as I noted, it stays connected if I use the timed connection mode. (Save for that one minute a day, of course)
0HELPFULS
Forums/ Controllers
2021-11-14 20:32:44
Keep PPPoE connected?
Is there a way to configure a PPPoE WAN connection to be "nailed-up", that is remain connected continuously? I have a remote site (controller is not on-site) with a PPPoE connection, and I get a ton...
0HELPFULS
12