Consolidare wrote I have put our eap65--outdoor in repeater mode. set it up to fixed ip address on 192.168.32.254.. have to ssid's 1 one 2.4 ghz. and 1 one 5 ghz. both ssid's I have enabled the guest...

wickedcool13 wrote Everytime theres a blackout the voucher that was "in-use" will extend its time or it will not expired, its buggy. Lets say someone has 1 hour voucher with pause time and theres a...

LJG5000 wrote I have an EAP 610 with an ethernet connection to a BE800 router. I use it to setup/provide guest networks. I noticed this morning, I was unable to connect to one of its non-guest...

Gmmg wrote I have 4 EAP-s 2x235 wall, one 245, and one 615-wall, the two 235-wall has a drop packet rate radio rx a rate of 30-50% percent. Is it a bad behavior? I deploy only 5GHz. Hi@Gmmg What...

Hi@Joe1975 When deploying the CPE products, each pair of CPE should be used in pairs. Each pair of CPE can be considered as the invisible Ethernet connection. And you will also need to connect an...

Hi @Xbit If you are using the portal > hotspot > voucher, please share the setting on your voucher manager page. When using the portal on controller, we need to confirm that the certain clients...