Hi @dickyam For the portal authentication page, currently you may try to check the address of the portal page when you first load it. The address + port number should allow you to access the portal...

nikitok wrote Hi, does device has capabilities to provide a more detailed logs? The only log entries I see is "System started" and "IP and mask set to xxx". I do not see any entries about when some...

dunxd wrote Tried the beta firmware on my OC200 managed EAP235-wall v1 access points. Very poor performance for Android and Windows clients after upgrade completed. Unable to even load this forum....

Borhan74 wrote Dear admin, from 3 months until today im suffering of offline then online troubles of my cloud monitoring of both my laptop and on my mobile apps frequently happened and specially this...

spd2612 wrote @spd2612 Well If I want this to work I think I am going to have to spend more money and buy a Omada Smart switch I dont see anyway to apply the profiles to my exsisting switch I seem to...

Yoghevos wrote I'm using an SDN software-based controller over Home Assistant OS (add-on). During the initial configuration, I enabled the 2FA. Recently I tried to disable it. I actually did so, and...