I was able to get it working following the instructions in the linked article to create an IP-Port Group ACL on allow access. I also had to change toe mDNS service from 'Gateway' to 'AP'. When it was...

I have an Omada network in an shared office environment. Two companies are sharing the space and share printers. The network has been configured with three VLANs: one for printers and one for each...

Does the EAP245 v3 support the Omada mesh mode? On the list page (https://www.tp-link.com/us/business-networking/omada-sdn-access-point/), it shows "Mesh", but on the product page itself it does not....

I am trying to use the DNS proxy ability available in the new Omada controllers. I am using the 1.1.1.1 service from Cloudflare. I have enabled the DNS Proxy over https (DoH) and checked Cloudflare....

@crrodriguez Using the 172.16... range is good advice but I didn't know about it when I set up the network. It would take a lot of time to change because all of our phones are set up to use a...

Is it possible to have a separate DHCP range for a VLAN? I.e., for the default vlan 0 network, the DHCP range is 192.168.100.1/22 and then VLAN #3 is 192.168.3.1/22 I have see a post elsewhere saying...