WiFi_Done_RightLV2Offline
Following: 0Followers: 0
Forums/ Switches
2 weeks ago
Re:IP-Port Group cannot be applied in Switch ACL because its port count exceeds the ACL limit
@buswedg sorry but I've not had any luck i'm afraid and the good ol folks at TP Link have also gone quiet.
0HELPFULS
Forums/ WiFi
2 weeks ago
Re:EAP 683 UR showing Rx dropped packets and Rx error on LAN
@Vincent-TP is it possible for TP Link engineers to amend the calculation mechanism for the EAP683UR? This is because when the AP is installed at client site and clients access the controller, they...
0HELPFULS
Forums/ Deco
2 weeks ago
Re:Deco BE85 SFP+ module compatibility
@David-TP thank you for the reply Is it possible for the engineers to actually confirm compatibility of the TL-SM311LM module so that its official? My use scenario is as follows: Modem =====> Deco...
1HELPFULS
Forums/ Deco
3 weeks ago
Deco BE85 SFP+ module compatibility
Hi @David-TP I read in a different post you stated that the Deco BE 85 SFP+ port is compatible with 1G optical transreceiver and that the following models below have been tested compatible. However I...
1HELPFULS
Forums/ WiFi
2024-09-03 03:47:56
Re:EAP 683 UR showing Rx dropped packets and Rx error on LAN
Hi @MarktheRed Apologies if I misread the length of cable run to your basement. Thanks for sharing your findings. I guess the decision is quite clear for your setup with the U6 enterprise. Hope it...
0HELPFULS
Forums/ WiFi
2024-08-31 00:05:23
Re:EAP 683 UR showing Rx dropped packets and Rx error on LAN
Hi @MarktheRed Looks like you're gonna have a busy, but hopefully, an interesting weekend comparing the EAP772 and U6 Enterprise. Hope you do have devices that can ake advantage of the 802.11be...
0HELPFULS