Not sure but these numbers seem quite high. I recall reading that there was an issue with the reporting but I think it was addressed in a firmware update. What can I do to investigate this?

@Hank21 Running OC200 but downloaded and tried local, which I assumed would not need anything special done for ports, however I already had the listed ports open. I did the update through OC200 this...

I am a bit confused on the LAN setting in the OC200 Hardware Controller. I plugged the OC200 into one of the modem / routers ports. It adopted without issue. All APs are adopted and connected....

@Linvincible I just chatted with live support and asked about this. I was told that you must have an Omada Gateway. This would be adopted by the controller and then it would show relevant information.

OC200 at modem EAP610 Outdoor Wired to Modem 3 EAP 225 Outdoor Wireless Downlinks What are these errors, should I be concerned and if so where do I start looking to resolve? Not having connection...

Thanks for the input. I will not be attempting to get roaming working and will not be using mesh, so it looks like it would only benefit me in being a means of central management. Once I get them...