Dear All, experiencing difficulties while migrating from an OC300 to a Windows-based Software controller. Situation: - migration from an OC 300 to the Windows-based software controller - both...

@d0ugmac1 Would support. Function over start-up time. Thx!

Quick question: Running ER8411 V1.0 with Firmware 1.2.1 and a OC300 V1.0 controller with Firmware 5.13.30.20. Can see IDS/IPS, but no DPI. Is the function not available to all? Thx & Br's Thomas

@d0ugmac1 found a solution to my problem, perhaps valuable/useful for you, too. Pls. see my post just above yours named "Access Point Detection" Thomas

Issue solved. Solution for my case was as follows: - configured the AP at the site of the controller (site 1) as stand-alone AP (assume this can also be done at a locally different site) - once done,...

Dear All, not sure if the right forum, or better to be placed in the WiFi/AP section. Following constellation: 2 remote sites (site 1 and site 2) controlled by an OC300 on site 1 2 tp link routers -...