Hello @Hank21, Thanks for your reply! Yes, I have followed all steps in the section "Controller migration". Forgot to mention that the OC300 controls two sites. Wanted however to migrate the full...

Dear All, experiencing difficulties while migrating from an OC300 to a Windows-based Software controller. Situation: - migration from an OC 300 to the Windows-based software controller - both...

@d0ugmac1 Would support. Function over start-up time. Thx!

Quick question: Running ER8411 V1.0 with Firmware 1.2.1 and a OC300 V1.0 controller with Firmware 5.13.30.20. Can see IDS/IPS, but no DPI. Is the function not available to all? Thx & Br's Thomas

@d0ugmac1 found a solution to my problem, perhaps valuable/useful for you, too. Pls. see my post just above yours named "Access Point Detection" Thomas

Issue solved. Solution for my case was as follows: - configured the AP at the site of the controller (site 1) as stand-alone AP (assume this can also be done at a locally different site) - once done,...