Hi @Mt.Faith If the port is only used to connect an access point, I think it is fine to assign all VLAN IDs to the Tag Network and set the Native Network to 19 >>>Yes, this is fine. Below is a guide...

Hi @nurix Are you using SG2210P? What's the model number of the POE device plugged into the port? After deteleing the config, please unplug the cable from the port and plug it back and see if the...

@DrMile Here are the recommended installation configurations. As shown in the image above, you will need 2 pairs of CPE210 and 2 outdoor EAPs. If your camera is 2.4G, I recommend the EAP110-Outdoor,...

Hi @flielguera Click this button, you will be redirect to the site view, then you will see a Client tab at the bottom menu. it looks like below:

Hi @flielguera No need to configure the switch. What's the status of the EAP on the controller, is it connected? Is there any wireless client connecting to the EAP access the Internet? Below is the...

Hi @Little_Old_Me Like mentioned in the other post, you don't need to add any other switch or EAP units. Just follow the guide to create a new guest wifi network.