n0sh1tLV2Online
Following: 0Followers: 0
Forums/ Controllers
2025-05-28 04:00:38
Re:Omada SDN Controller_V5.15.24 Pre-Release Firmware (Update on 14th May, 2025)
@Vincent-TP @Hagi79 I can see it in the WAN settings under 'Advanced DHCP Options' after updating my ER8411 to 1.3.1.
0HELPFULS
Forums/ Gateways
2025-05-28 03:47:56
Re:ER8411 standalone - Link backup - fallback to primary not working
@CostinR1 You can disable the WAN Settings Overrides if you go the Controller route. That means that the configuration in standalone mode will transfer when adopted. I can confirm that when the...
0HELPFULS
Forums/ Controllers
2025-05-24 19:09:32
Re:Omada SDN Controller_V5.15.24 Pre-Release Firmware (Update on 14th May, 2025)
@Hagi79 You need the adapted gateway firmware.
0HELPFULS
Forums/ Gateways
2025-03-18 01:03:08
Re:ER8411 V1 1.3.0 Build 20250305 Pre-Release Firmware (Released on Mar 14th, 2025)
@Clive_A Thanks for the quick reply. I did a factory reset, updated in standalone mode and then adopted it and its working again. I don't know what happened.. As for the ACL rule it was a GW rule to...
0HELPFULS
Forums/ Gateways
2025-03-16 23:35:22
Re:ER8411 V1 1.3.0 Build 20250305 Pre-Release Firmware (Released on Mar 14th, 2025)
@Clive_A Updated to 1.3.0 without any issue by using the 'Firmware' section in Global view. Had to rollback the firmware cause I had issues with inter-vlan routing and couldn't figure it out but the...
0HELPFULS
Forums/ Gateways
2025-03-11 19:04:01
Re:ER8411 - Configuring Syslog on port 1514
@KSab You can set it up under Global View and/or via the site settings if you are using a controller. In standalone mode I don't know if you can. Under Global View, Settings -> Controller Settings ->...
0HELPFULS