@Vincent-TP Hi, this sounds like a workaround but I need to understand what the devices do... I disabled ARP-to-Unicast Conversion on Wifi und Spanning-Tree on the Switches (both are default settings...

Hi @Vincent-TP the RE700X has a fixed IP and I tried the DHCP on it yesterday. That worked first for maybe 1 minute, but than I got the DHCP decline messages in the Repeater Log and it was the same...

@Vincent-TP Hi, it is RE700X(EU)_V1_1.1.4 Build 20230509 Firmware from 2023-07-14. When I connect it to another network like Fritz!Box, the repeater works as expected. Yes, I put another PC which was...

@Vincent-TP Hi again, I was not successful with the repeater in 2.4 Ghz. I did a factory reset and connected it only using 2.4 Ghz to the EAP. Set fixed IP address for the repeater and disabled DHCP...

@Vincent-TP Okay, thanks for the answer! All LEDs were on/blue after config. I would try again this evening and only use the 2.4 Ghz mode were I set a fixed channel of 6 which should be supported by...

Hi, I built a network of Omada Devices, with one Gateway, 3 switches, 1 Controller and 5 EAPs. Now my intention was to get wifi/internet to an appartment which can be reached by the wifi of...