@MrTom @Vincent-TP @NeilR_M Okay, it is definitely the cabling. I took the device down this morning and first demonstrated that all of the wired ports work with separate 12V power, then that Port 1...

@Vincent-TP The client-side wireless works great. It is only the wired network that is the issue. When you say "resetting the device" do you mean going to the System->Reboot/Reset and clicking on the...

@MrTom I ran v1.1.2 for a while and it didn't help. The thing is, there's an old saying that goes "90% of all networking problems are cabling problems and 90% of the rest are configuration problems."...

@NeilR_M I don't think a downgrade is possible. I didn't write down what the old firmware version was, but even if I did it says "rolling back to any of the previous versions are forbidden". I would...

@NeilR_M I don't need to do all that. When I go to the Bridge Network page, it shows the both of the units on the bridge network, and it's already listed in the Bridge APs list. I can also do the...

@NeilR_M Standalone mode. If I plug the cable from the PoE injector into a laptop, I don't get link so there's no IP address. The version on the client reports "1.1.3 Build 20250805 Rel. 76570(5553)"