I have the port issue resolved after talking to TP-Link technical support. The solution was to set the Negotiation Mode to 1000M Full-duplex for Port1 (SFP+ WAN1) and Port2 (SFP+ WAN/LAN2) at...

@GRL I originally had them configured for 10GB bandwidth. They weren't working with that configuration, either.

I think I have the policy routing situation addressed. I needed to change the destination settings to IPGROUP_ANY. Things seems to be working with that change. Does anyone have any thoughts about the...

I finally had a chance to install my router yesterday. I had some success, and some challenges. The challenges: WAN ports SFP+ WAN1 and SFP+ WAN/LAN2 are showing "Link Down" connection status. I'm...

@herman12 thanks, @GRL shared the same advice. I've made changes to use policy routing instead, but I haven't had a chance to test the configuration to confirm that it works.

@GRL I've made some changes to my configuration after reading up on policy routing. I've configured the WAN-SFP+ port to use the first static IPv4 address from my block. I've configured the 4...