Hi @xSellize Yup, your interpretation is correct. When a gateway, switch, ap, etc., is removed/reset from the controller, you can just re-adopt it to the controller who will then synchronize all...

Hi @shardy Did you configure any QoS or bandwidth control on the gateway that might restrict the data flow?

Hi @MarkTee Could you please show up how "IPV6 enable" option is not displayed on your GUI? When I navigate to the GUI > Network > IPV6 > WAN, I can find the Enable option easily. And regarding the...

Hi @b-shu What's the hardware version of your ER605? Is it V2.0? If so, you may refer to this link: ER605 | Omada Network Support

Hi @JoshControl 1. The switch IP will not get assigned to the default VLAN; instead, it depends on the VLAN configuration of its access port. 2. Now you have assigned VLAN10 to the switch. If you...

Hi @Galt Thanks for your feedback. Your request is understandable. Unfortunately, this is not technically possible under current regulations. This is a regulatory requirement to ensure the AP...