@bachoo786 HI, I would like to follow up on your case by email, and could you please help me check the following information: 1. Were you able to reproduce this issue all the time, for example, each...

@Microt Hi, Would there be any error message when you failed to access the camera remotely? Or Did you need to enable the remote control option on the BayitCam APP? Have you set up any parental...

@zariftjwr HI, after the IPv6 setup, was the Deco M5 solid green? May I know who is your internet service provider and Did it also provide IPV4 service? ---If yes, did the IPv4 work fine? Could you...

Thanks, Alexandre. Hi，@Abdullabh Your issue is quite like case 1 on this link: https://community.tp-link.com/en/home/forum/topic/271538 It is quite like your control switch is not supported IEEE...

@BobSpence Hi, I think your subnet mask might be 255.255.252.0, instead of 255.255.255.0, which is under Deco APP>More>advanced>LAN IP.

This article applies to: Deco X90 V1 with firmware 1.1.0 Issue phenomenon: After upgrading to firmware 1.1.0, there is a feature called “Network Optimization” in the Deco app. Under certain...