quadrophenicLV2Online
Following: 0Followers: 0
Forums/ Business Switches (Standalone)
2020-08-19 13:59:51
Re:TL-SG2210P PoE+ 802.3at Support
@No_space_left Has anyone dared to try and upgrade the Sg2210P V1 with the V3 firmware? I bought this switch assuming compatability with omada SDN.
0HELPFULS
Forums/ Omada EAP
2020-08-16 09:28:16
Re:1 Gbps ethernet, but only 150-200 Mbps WiFi.
Hi @Yoel Sadly my actual ISP connection isnt anywhere near the speeds you have so I cannot comment on actual download rates. The only thing I will say is that in the latest firmware for EAP225...
0HELPFULS
Forums/ Omada EAP
2019-10-16 15:18:17
Re:1 Gbps ethernet, but only 150-200 Mbps WiFi.
@Lynild Just a final follow up on my issue. I dug out my ISP router (BT Smarthub 6 I think) which tested to the same 305mbps limit that I saw on the EAP and my Netgear XR500 so I conclude the...
0HELPFULS
Forums/ Omada EAP
2019-10-14 14:37:52
Re:Wireless N outdoor access point Question can I connect direct to router
@Paulbrom2001 Hi Paul, yes you can use an EAP110-Outdoor as a standalone access point. You will need to run an ethernet cable from your router to the supplied PoE injector, then another ethernet...
0HELPFULS
Forums/ Omada EAP
2019-10-12 15:14:15
Re:1 Gbps ethernet, but only 150-200 Mbps WiFi.
@Lynild No, sadly I haven't been able to recreate the results I was previously getting and there were far too many variables to try and pin down the cause and I ran out of patience. The strangest...
0HELPFULS
Forums/ Omada EAP
2019-10-08 11:24:37
Re:Does EAP110 Require a Constant LAN connection to the Router?
@dnelms61 EAP110 requires a lan connection to pass data back to the network. It cannot be used over mesh if that was your intention. EAP225 outdoor supports mesh but you would need another EAP225...
0HELPFULS
123...8