@Hank21 Thanks!

@rickk1000 I discovered an alternative to resetting the EAPs. After I installed the replacement OC200, within Omada controller, the EAPs were shown, and the status of each was Managed By Others. This...

After what seemed like a successful upgrade to the current OC200 firmware, the OC200 failed reboot and remained off line. With help from TP-Link support, we attempted to connect to the OC200. These...

Fae wrote Dear @Bobby1859, Sorry I didn't notice that my previous reply was deleted, now it's restored. For your case, may I check the cable you are using to connect between the EAP and PoE switch?...

@Bobby1859 An additional question: Why do the log events stop when I change the EAP 245 V3 power source from a TP-Link 5 port Gb PoE af switch to the power injector? Thanks,

@Bobby1859 I received the following via a message from Fae in the TP-Link Community: “Fae replied your subscription EAP Changed IP address, Log Entry. The EAP245 V3 supports both 802.3af and 802.3at,...