When I try to add my printer to the IOT network using MAC address I can choose between two MAC addresses which does not match the DECO mac address. The last 2 characters are wrong, says "-4E" should b

X60 error code. How to resolve?

I have a set of 2 X90 where I do not need the WiFi backhaul between them, since I use wired ethernet instead. Would be great if the system understands this configuration, and only then enables turning

Hi, I have upgraded my Deco mesh from M9 Plus to X50s and now have fully functioning set of two Deco M9 Plus I no longer need. I hate to see it going to recycling, I am not interested in selling these

I am lookig to get wifi connectivity for my Blink camera system out to my hunting blind. It's about a 500 ft. haul out to that point from my outermost mesh router. The main routers are located in the

I've several XE70PRO connected together as a network. is it possible to connect (wired) another M5 but to define it as a separated network? I tried configuring the M5 as dynamic IP (DHCP?) but it fail