I composed my home wifi mesh by 2 X50 + 2 M9 Plus + 2 M5 with one of the X50 as main router. My ISP recently changed to Map-E so I cannot setup my port forward to allow and limit the incoming connecti

The router shows the network devices/clients which are wireless as wired, for example, my mobile phone or a smart wifi switch is displayed as wired. In addition, I have connected the Deco E4R as acces

Hi all, currently i have Deco P9, but would like to extend cover and start using HomeShield. If i setup a X75 as main Deco, can i protect my mesh network with it, or would in need to change all equipm

Dear tp-link community, I hope you can help me on the following issue: Yesterday I received my Deco X50-5G and set up was flawless. Speedtest result on my iPhone was 800mbit/sec so not on the slow sid

Hello, My country is not available on the TP-link website, and i would like to updtae my firmware on the BE230 and i also have AX55pro and the AX53. Since, when upgrading the firmware it is written to

As the title says. When I go to NAT Forwarding - port forwarding and add a port and save it doesn't open. I'm using several port checker websites to check. However, if I set a port to open in the UPnP