Hi. I have been spending time trying to set up my system since I was able to go from a flaky 2Mb copper broadband line to a 300Mb fibre cable from Gigaclear. Gigaclear set up their router to a bridge

I have just set up a DECO M9 Plus Mesh in router mode linked to my Archer VR600 router. I have a Wifi printer connected to the DECO network. I also have a PC connected to my VIVE VR Setup. This uses a

Hi There, Novice in need of assistance. I have a DVR connected to Deco M5 in router mode. I can view camera footage when connected to wifi of the same network but I cannot view remotely. I followed po

Good afternoon, I had 3 deco P7 installed. On the label I can see EU V1.0 I bought a new 3pack but all 3 P7 aren't recognize from old. Label EU V1.1 what can I do to solve the problem? Thank

I have followed all the in instruction accordingly. (including turning on VLAN to choose Malaysia Unifi). the light on the deco remains Red. this are the steps I did. 1. turn off unifi modem 2. connec

I know that this has come up 1000 times before, but I don't see any good solutions. The TP-Link smart switch wall plates are the best out there, but they don't make 2 or 3 gang versions as far as I ca