I recently obtained an AX53 router and it is setup and working. The firmware status is as shown below: Router Firmware Status I have unsuccessfully tried to update the firmware, several times, via the

Hi, I am in the UK and have 3 AX72s setup in a router -> easy mesh config (i.e. 2 of them are the easy mesh nodes). I noticed that my router is showing: I tried clicking update before and it went thro

For reasons of my own, I am trying to remove (the POS that is) the BT Smart Hub 2 from my network, which was made up of 5 Deco XE75 Pros in Access Point mode. Broadband is 1000Mbs FTTP from BT, with a

Hello there, when I activate IPv6 the access speed to sites and services using this protocol does not exceed 50 Mbps. When using only IPv4 the speed reaches 300+ Mbps. The Starlink router is switched

As the subject says, "Unable to connect to Deco" on the Deco app, Wifi is working as normal with the Deco light still green, however I need to reboot the network in order to restore control from the D

I am struggling to get IPv6 working on my home network with the Deco XE75. I know my ISP supports it; if I connect directly to the SSID advertised from the modem/router, my device gets an IPv6 address