Currently I have an ER605 V2.0 running Firmware 2.3.1. Recently (end of 2025) 2.3.2 and 2.3.3 were release. Inorder to upgrade to 2.3.3 you first have to be on 2.3.2. This makes sense for the upgrade.

My ER605 V2.0 is running 2.3.0 Build 20250428 Rel.18967. I downloaded the new 2.3.1 Build 20251015 Rel. 78291 and performed the upgrade. It installs and reboots without error, but when I login the Sta

I have the following hardware: ER605 v2.0 SG2428P v5.20 EAP613(US) v1.0 EAP610(US) v1.0 With the following vlans: Default vlan IoT vlan Cameras vlan I have setup ACL to let main vlan access IoT vlan,

I was able to setup a Location block as a base firewall rule. I am blocking all non-US/Canada websites under the Gateway ACL section using the "Location Group" and checking all countries except the US

Recently bought an er605 and looking to run nordvpn at the router level which means anything behind it will be running through Nordvpn. Is there any way to setup one laptop to be able to pass through

Hi I have installed this in my office to create a load balancer. So 2 modems individual with PPOE wires are going in WLAN and WLAN/LAN1 and load balancing working fine. now all network output to wired