Ethernet Backhaul is a feature that makes it possible to wire the Deco units together to optimize the bandwidth and network stability. Normally, after wired Deco units with an Ethernet cable, the Ethe

I have a TL-R600VPN on the way. I'd like to configure it in my SOHO with some existing gear... Optimum internet provided ARRIS TM1602 Netgear Nighthawk M1 (MR1100-100NAS) Linksys WiFi Velop w/4 nodes

When I connect with my PC to de Deco X20 I can see the status of f.e. the wireless connection. However I can not change these setting (f.e. other channel nr for 2.4 and 5 G). So my question is: How do

I have a TL-R600VPN V4. Configured like a gateway with a telecom modem attached to the WAN port. It works, Internet connection, NAT, DNS forwarding, UPnP, VPN (IPsec peer to peer & L2TP server), DHCP

It seems the M5 uses a wide 40MHz channel in 2.4Ghz mode instead of the recommended 20MHz. How can we change that? Also would be nice if we could to change the wifi channels in advanced settings. Will

Hi, My deco m9 is operating in channel 44, which is the same as my neighbor's wifi. May I request the feature to be able to change wifi channel manually to avoid wifi congestion? Since you guys are be